Chamberlain RJO20 RJO20 Owner s Manual - English - Page 31
Internet Gateway, To Erase All Codes From the Door Control(myQ® Control Panel) Memory
View all Chamberlain RJO20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Getting Connected Internet Gateway The Internet Gateway gives you control of your garage door from your internet-connected computer or mobile device, letting you use the myQ® app to open and close your door, get alerts, and set schedules from anywhere. In addition, connected smart garage door openers also receive software updates to ensure the opener has the latest operational features. You must have your Internet Gateway set up in the myQ® app to use it with the control panel. Before you begin, you will need: • Wi-Fi enabled smartphone or tablet • Broadband internet connection and router • Wi-Fi signal in the garage (2.4 Ghz, 802.11b/g/n required) • Password for your home network (router's main account, not guest network) • myQ® serial number located on the garage door opener Figure 1 Router Green LED Power Chamberlain Internet Gateway Connect the Internet Gateway to your router and power. When the green LED on the gateway has stopped blinking and glows steadily, it is connected to the internet. Setup and Connect Your Gateway and Opener in the myQ® App 1. Download the myQ® App and set up your account. 2. Follow the instructions given in the app to find and connect your Internet Gateway. 3. Next, select the device you wish to add (Garage Door Opener). 4. Once you select the opener in the app, you have 3 minutes to press the LEARN button two times on the myQ® control panel. The red LEARN LED will turn on. (Figure 2) 5. When the red LEARN LED turns off, programming is complete. Once the opener is learned and appears in the app device list, name your device (e.g., Garage Door Opener). NOTE: If you are unable to add the myQ® Control Panel to your Chamberlain Internet Gateway, erase all codes from the door control and try again. Note that you will need to reprogram any accessories you wish to use. When the Chamberlain Internet Gateway connects to the internet, the green LED will stop blinking and will glow steadily. Figure 2 Red Learn LED To Erase All Codes From the Door Control (myQ® Control Panel) Memory Erase all remote controls and keyless entries: 1. Press and hold the LEARN button on the control panel until the red learn LED goes out (approximately 6 seconds). All remote control and keypad codes are now erased. Reprogram any compatible accessory you wish to use. Erase all devices (including myQ® enabled accessories): 1. Press and hold the LEARN button on the control panel until the red Learn LED goes out (approximately 6 seconds). 2. Immediately press and hold the LEARN button again until the red Learn LED goes out. All codes are now erased. Reprogram any compatible accessory you wish to use. myQ® Control Panel 31