Chamberlain RJO20 RJO20 Owner s Manual - English - Page 18

Installation (continued) INSTALLING THE BRACKETS The brackets house the safety reversing sensors in a fixed, secure position so the safety reversing sensors will face each other across the garage door, with the beam no higher than 6" (15 cm) above the floor. Be sure power to the opener is disconnected. Choose one of the following installations. OPTION A: Track Installation (Recommended) 1. Slip the curved arms over the rounded edge of each door track, with the curved arms facing the door, and make sure brackets measure no higher than 6" (15 cm) above the floor. Door 2. Snap bracket into place against the side of the track. It should lie flush, with the lip hugging the back edge of the track, as shown. If your door track will not support the bracket securely, see Option B: Wall Installation. Door Track Safety Reversing Sensor Bracket OPTION B: Wall Installation 1. Place the bracket against the wall with curved arms facing the door. Be sure there is enough clearance for the sensor beam to be unobstructed. 2. If additional depth is needed, an extension bracket (Model 041A5281-1) or wood blocks can be used. See Accessories section. 3. Use bracket mounting holes as a template to locate and drill (2) 3/16" diameter pilot holes on the wall at each side of the door, no higher than 6" (15 cm) above the floor. 4. Attach brackets to wall with lag screws (not provided). If using extension brackets or wood blocks, adjust right and left assemblies to the same distance out from the mounting surface. Make sure all door hardware obstructions are cleared. If Option B will not work, see Option C: Floor Installation. OPTION C: Floor Installation 1. Use wood blocks or extension brackets (see Accessories) to elevate sensor brackets so the lenses will be no higher than 6" (15 cm) above the floor. 2. Carefully measure and place right and left assemblies at the same distance out from the wall. Be sure all door hardware obstructions are cleared. 3. Fasten to the floor with concrete anchors as shown. Fasten Wood Block to Wall with Lag Screws (not provided) Safety Reversing Sensor Bracket Door Lag Screws (not provided) Extension Bracket (See Accessories) (Provided with Extension Bracket) Door (Provided with Extension Bracket) Safety Reversing Sensor IGWnsaairdlalege Bracket Attach with Concrete Anchors (not provided) Door Safety Reversing Sensor Bracket IIGGWWnnssaaaaiirrddllaalleeggee IIGGWWnnssaaaaiirrddllaalleeggee 18