Chamberlain RJO20 RJO20 Owner s Manual - English - Page 27
Operation, Using the Door Control myQ, Control Panel
View all Chamberlain RJO20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Operation (continued) Using the Door Control (myQ® Control Panel) NOTE: Due to power consumption, this door control (Model 041A7928-3) cannot be used in conjunction with another wired door control connected to your garage door opener. If an additional door control is needed, the wireless door control model 041A7773-1 can be programmed to the door control (Model 041A7928-3). To program the 041A7773-1 to the myQ® Control Panel, follow the remote control programming steps. Push Bar 1 Minute TTC LED 5 Minute TTC LED 10 Minute TTC LED HOLD OPEN Button for the TimerTo-Close (TTC) LIGHT Button Motion Sensor FEATURE PUSH BAR LOCK Designed to prevent operation of the door from hand-held remote controls. However, the door will open and close from the Door Control, keypad, and myQ® App. MOTION SENSOR This feature will automatically turn on the garage door opener lights when motion is sensed. The lights will come on for 4-1/2 minutes, then shut off. TIMER-TO-CLOSE (TTC) The TTC feature automatically closes the door after a specified time period (1, 5, or 10 minutes). Once the TTC has been set and the door is open, the LED for the selected close interval will blink and begin to count down to close the door. The control panel will beep and the garage door opener lights will flash before closing the door. The TTC feature will deactivate if the garage door encounters an obstruction twice; or the safety reversing sensors are incorrectly installed. The garage door will reverse open and WILL NOT close until the obstructions are clear or the safety reversing sensors are correctly installed. When the obstruction has been cleared or the safety reversing sensors have been aligned, the door will close when the garage door opener is activated HOW TO: Press the push bar to open/close the door. Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as long as the lock feature is activated and your handheld remote control will not operate your door at this time. Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will stop flashing and normal operation will resume. Activate/Deactivate: Slide the motion sensor switch ON or OFF. Activate: Press and hold the ON button until one of the TTC LEDs light up. Then press the ON button again to cycle through the time interval options (the corresponding TTC LED will light for each time interval). The garage door opener light bulbs will blink as confirmation. Deactivate: Press and hold the OFF button until all TTC LEDs turn off and a beep is heard from the control panel. To suspend the TTC: To suspend the TTC and temporarily hold the door open, press and release the HOLD OPEN button (the HOLD OPEN LED will turn solid). The TTC will remain suspended until the HOLD OPEN button is pressed again or the garage door opener is activated from another device (door control, remote control, keypad, etc.). 27