Cisco 2501 Configuration Guide - Page 9
Configuring the Global Parameters, setup - terminal server
View all Cisco 2501 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Configuring the Access Server Once the access server has determined that AutoInstall is not configured, it will default to the setup facility. If the serial (WAN) cable is not connected, the access server will boot from Flash memory and go into the setup facility. Note You can run the setup facility any time you are at the enable prompt (#) by entering the command setup. Configuring the Global Parameters When you first start the setup program you must configure the global parameters. The global parameters are used for controlling system-wide settings. Use the following procedure to enter the global parameters: Step 1 Connect a console terminal by following the instructions in the section "Connecting the Console Terminal and Modem" in the chapter "Installing the Cisco 2500 Series Access Server" and then boot the access server to the EXEC prompt (Router>). Step 2 When you have booted from Flash memory, the following information will appear after about 30 seconds. When you see this information displayed, you have successfully booted your access server: System Bootstrap, Version 4.14(8), SOFTWARE Copyright (c) 1986-1995 by cisco Systems 2500 processor with 16384 Kbytes of main memory Loading igs-c-l.110-0.7 at 0x3000040, size = 3865444 bytes [OK] F3: 3779532+85880+173868 at 0x3000060 Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. Configuring the Cisco 2500 Series Access Server 4-9