Cisco ASR1004-20G-SEC/K9 Software Guide - Page 314
Incorrect QL values, network-clock errors
View all Cisco ASR1004-20G-SEC/K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 314 highlights
Configuring Synchronous Ethernet Chapter 10 Synchronous Ethernet Support Table 10-3 Problem Troubleshooting Scenarios (continued) Solution • Reproduce the current issue and collect the logs using the debug network-clock errors, debug network-clock event, and debug network-clock sm RP commands. Warning We suggest you do not use these debug commands without TAC supervision. Note Contact Cisco Technical Support if the issue persists. Incorrect QL values when you use the show network-clock synchronization detail command. • Use the network clock synchronization SSM (option 1 |option 2) command to confirm that there is no framing mismatch. Use the show run interface command to validate the framing for a specific interface. For the SSM option 1, framing should be SDH or E1, and for SSM option 2, it should be T1. • Reproduce the issue using the debug network-clock errors and debug network-clock event RP commands or enable the debug hw-module subslot command. (This is specific to SIP-400). Warning We suggest you do not use these debug commands without TAC supervision. 10-18 Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide OL-16506-10