Cisco ASR1004-20G-SEC/K9 Software Guide - Page 68
SUMMARY STEPS, DETAILED STEPS, Command or Action, Purpose
View all Cisco ASR1004-20G-SEC/K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
ISSU Upgrade for Redundant Platforms Chapter 4 Software Upgrade Process Note This procedure will only work if the current RPs are already running consolidated packages. SUMMARY STEPS 1. ip tftp source-interface gigabitethernet slot/port 2. copy tftp: URL-to-target-location 3. copy source-file-system:filename standby-destination-filesystem 4. dir URL-to-target-location dir URL-to-target-stby-location 5. issu loadversion rp upgrade-rp-number standby-file-system:filename 6. issu runversion 7. telnet ip-address port 8. issu acceptversion 9. issu commitversion 10. show version, show version active-RP running, show version active-RP provisioned show platform show running-configuration 11. hw-module slot RP slot number reload DETAILED STEPS Command or Action Step 1 ip tftp source-interface gigabitethernet slot/port Example: Router(config)# ip tftp source-interface gigabitethernet 0 Purpose Specifies the Gigabit Ethernet TFTP source-interface to be configured: slot/port-Specifies the location of the TFTP source-interface. Note To copy a file using TFTP through the Management Ethernet interface, the ip tftp source-interface GigabitEthernet 0 command must be entered before entering the copy tftp command. Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide 4-6 OL-16506-10