Cisco UC560-FXO-K9 Quick Start Guide - Page 4
Before You Begin - card
View all Cisco UC560-FXO-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
1 Before You Begin Before you begin the installation, make sure that you have the following: For Hardware Installation: • Cisco IP phones • One or more Power over Ethernet (PoE) switches for connecting IP phones or computers. We recommend that you use Cisco ESW 500 Series switches. • Cables - Ethernet cables (Category 5 or higher) for connecting IP phones and computers, WAN interfaces, or other devices. One Ethernet cable is included with the UC 560 and one cable is included with each IP phone. - RJ-11 cable for analog Line (FXO) and Phone (FXS) connections. - RJ-45 (non-Ethernet) cable for ISDN (BRI) connections. - RJ-48 cable for ISDN (PRI) T1/E1 connections (only needed if a T1/E1 voice interface card is installed). You can purchase the RJ-45 and RJ-48 cables from your telephony service provider or reseller. The RJ-11 cable can be purchased from any electronics store. - (Optional) Cable for connecting an external audio device to the 3.5 mm Music on Hold (MoH) port. - (Optional) Additional Voice Interface Cards (VIC) to insert in the VIC slots. • Compact flash memory guard for protecting the compact flash memory slot. Included are two Torx T5 screws and a Torx wrench (size T5) for installing it. • Mounting brackets and screws for mounting the unit in a 19 -inch rack. 2 Cisco Unified Communications 500 Series Model UC 560 Quick Start Guide