Cisco VC220 User Manual - Page 12
Suggested Next Steps, Adjusting the Lens
View all Cisco VC220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
7 Suggested Next Steps Adjusting the Lens After viewing the live image on the web-based configuration utility, adjust the camera lens, zoom factor, and focus range as needed. NOTE Do not over rotate the camera lens. Doing so will damage the lens. To adjust the viewing angle: STEP 1 Loosen the pan screw and turn the lens module left and right. Upon completion, tighten the pan screw. STEP 2 Loosen the tilt screws on both sides of the camera and then turn the lens module up and down to point the lens at the area of interest. Upon completion, tighten the tilt screws. STEP 3 Loosen the image adjustment screw and then turn the lens to adjust the image orientation. Upon completion, tighten the image adjustment screw. Rotate the screw Turn the lens 1 Loosen Tighten 2 Loosen Tighten Tighten Loosen 3 STEP 4 Loosen the zoom controller to adjust the zoom factor from Wide to Telephoto. Upon completion, tighten the zoom controller. 12 VC 220 Dome WDR Day/Night PoE Network Camera Quick Start Guide