Cisco WAP2000 User Guide - Page 11

Chapter 5 Advanced Configuration Setup > Basic Setup with Static IP • LocalIPAddress TheIPaddressmustbeuniquetoyour network. The default IP address is 192.168.1.245. • Subnet Mask The subnet mask must be the same as the LAN that your Access Point is connected to. The default is 255.255.255.0. • Default Gateway Enter the default gateway address, typically this is the IP address of your router. • Primary DNS (Required) and Secondary DNS (Optional) Your ISP will provide you with at least one DNS (Domain Name System) Server IP address. Change these settings as described here and click Apply to save your changes. Help information is available on the right side of the screen. Setup > Time This screen allows you to change the Access Point's time settings. The correct time setting can help the administrator to search the system log to identify problems. Current Time Displays the current time setting. Manually Select this option to set the date and time manually. • Date When the time is manually configured, this field is used to select the current date from the pull-down menus. • Time When the time is manually configured, this field is used to enter the time. The time is enter in a 24 hour format (hour : minutes : seconds). NTP Select this option if you want the Access Point to contact a public time server to get the current time. • Time Zone When NTP is enabled, the appropriate time zone must be selected. • Automatically adjust clock for daylight saving changes Select this option if you are in using the Access Point in a location that observes daylight saving time. User Defined NTP Server Enable this option if you have set up a local NTP server. Default is Disabled. NTP Server IP Enter the IP address of user defined NTP Server. Change these settings as described here and click Apply to save your changes. Help information is available on the right side of the screen. Wireless > Basic Wireless Settings Change the basic wireless network settings on this screen. The Access Point can connect to up to four wireless networks (SSIDs) at the same time, so this screen offers settings for up to four different SSIDs. Setup > Time You can set the time either manually or use the NTP option to automatically set the time from a time server if the Access Point can access the public Internet. NTP is the default setting. Wireless-G Access Point with Power Over Ethernet Wireless > Basic Wireless Settings Wireless Network Mode Select one of the following modes. The default is Mixed. • Disable This option disables wireless connectivity completely. This is useful during system maintenance.