Cisco WAP2000 User Guide - Page 20

Chapter 5 Change these settings as described here and click Apply to save your changes. Help information is available on the right side of the screen. Administration > Factory Default On this screen you can restore the Access Point's factory default settings. Advanced Configuration Administration > Factory Default Note any custom settings before you restore the factory defaults. Once the Access Point is reset, you will have to re-enter all of your configuration settings. Restore Factory Defaults To restore the Access Point's factory default settings, follow the steps below: 1. Click the Yes option. 2. Click the Apply button. 3. Click OK to confirm that you want to restore the factory default settings. Your Access Point will reboot and come back up with the factory default settings in a few seconds. Administration > Firmware Upgrade On this screen you can upgrade the Access Point's firmware. Do not upgrade the firmware unless you are experiencing problems with the Access Point or the new firmware has a feature you want to use. Administration > Firmware Upgrade To upgrade the Access Point's firmware: 1. Download the firmware upgrade file from the Linksys website, www.linksys.com. 2. Extract the firmware upgrade file on your computer. 3. On the Firmware Upgrade screen, enter the location of the firmware upgrade file in the field provided, or click the Browse button to find the file. 4. Click the Apply button, and follow the on-screen instructions. Help information is available on the right side of the screen. Administration > Reboot On this screen you can reboot the Access Point. Wireless-G Access Point with Power Over Ethernet Administration > Reboot This feature is useful when you need to remotely reboot the Access Point. Device Reboot To reboot the Access Point, click the Yes option. Click Apply and the Access Point will reboot itself. Help information is available on the right side of the screen. 16