Cisco WAP2000 User Guide - Page 8
Installation - set up
UPC - 745883578337
View all Cisco WAP2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Chapter 4 Installation Chapter 4: Installation Placement The Access Point can be placed horizontally on a flat surface such as a desktop so it sits on its four rubber feet or it can be mounted on a wall. Desktop Placement Wall-Mount The unit has two sets of wall-mount slots so that it can be mounted either vertically or horizontally. You will need 2 suitable screws to mount the Access Point. Suggested Mounting Hardware 2.5-3 mm 4-5 mm 1-2 mm NOTE: Linksys is not responsible for damages incurred by insecure wall-mounting hardware. 1. Determine where you want to mount the Access Point. Ensure that the wall you use is smooth, flat, dry and sturdy and make sure the location is within reach of the power outlet. 2. Drill two holes into the wall for either vertical or horizontal placement. NOTE: The printed Quick Installation Guide that accompanies the Access Point includes templates that can be used for spacing between holes. Horizontal Mounting NOTE: The Access Point should be oriented as shown above for horizontal mounting. Vertical Mounting NOTE: The Access Point should be oriented as shown above for vertical mounting. 3. Insert a screw into each hole, and leave 3 mm of its head exposed. 4. Maneuver the Access Point so the wall-mount slots line up with the two screws. 5. Place the wall-mount slots over the screws and slide the Access Point down until the screws fit snugly into the wall-mount slots. Wireless-G Access Point with Power Over Ethernet