Cisco WAP2000 User Guide - Page 9
Connecting the Access Point - wireless g access point with power over ethernet
UPC - 745883578337
View all Cisco WAP2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Chapter 4 Installation Connecting the Access Point 1. Connect the antennas to the antenna connectors on the Access Point. Connect the Antennas 2. Adjust the two antennas so that they form a 90 degree angle for best performance. 5. If you are not using PoE (Power over Ethernet), then connect the included power adapter to the Access Point's Power port. Then plug the power adapter into an electrical outlet. The LEDs on the front panel will light up as soon as the Access Point powers on. Adjust the Antennas 3. Connect your Ethernet network cable to your network router or switch. LINK/ACT PoE LINK/ACT PoE LINK/ACT Gigabit LINK/ACT Gigabit Connect the Power Installation is complete. For advanced configuration information, proceed to the next chapter. Connect the Ethernet cable to the Router or Switch 4. Connect the other end of the network cable to the Access Point's Ethernet port. Connect the Ethernet cable to the Access Point NOTE: If your router or switch provides Power over Ethernet, then step 5 is not necessary. Wireless-G Access Point with Power Over Ethernet