Cisco WS-C3560E-48PD-SF Command Reference - Page 367
service-policy
View all Cisco WS-C3560E-48PD-SF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 367 highlights
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands service-policy service-policy Use the service-policy interface configuration command on the switch stack or on a standalone switch to apply a policy map defined by the policy-map command to the input of a physical port or a switch virtual interface (SVI). Use the no form of this command to remove the policy map and port association. service-policy input policy-map-name no service-policy input policy-map-name Syntax Description input policy-map-name Apply the specified policy map to the input of a physical port or an SVI. Note Though visible in the command-line help strings, the history keyword is not supported, and you should ignore the statistics that it gathers. The output keyword is also not supported. Defaults No policy maps are attached to the port. Command Modes Interface configuration Command History Release 12.1(19)EA1 12.2(25)SE 12.2(25)SED Modification This command was introduced. A policy map can now be applied to a physical port or an SVI. Hierarchical policy-maps can now be applied to an SVI. Usage Guidelines Only one policy map per ingress port is supported. In software releases earlier than Cisco IOS Release 12.2(25)SE, policy maps can be configured only on physical ports. In Cisco IOS Release 12.2(25)SE or later, policy maps can be configured on physical ports or on SVIs. When VLAN-based quality of service (QoS) is disabled by using the no mls qos vlan-based interface configuration command on a physical port, you can configure a port-based policy map on the port. If VLAN-based QoS is enabled by using the mls qos vlan-based interface configuration command on a physical port, the switch removes the previously configured port-based policy map. After a hierarchical policy map is configured and applied on an SVI, the interface-level policy map takes effect on the interface. In software releases earlier than Cisco IOS Release 12.2(25)SE, you can apply a policy map only to the incoming traffic on a physical port. In Cisco IOS Release 12.2(25)SE or later, you can apply a policy map to incoming traffic on a physical port or on an SVI. In Cisco IOS Release 12.2(25)SED or later, you can configure different interface-level policy maps for each class defined in the VLAN-level policy map. For more information about hierarchical policy maps, see the "Configuring QoS" chapter in the software configuration guide for this release. 78-16405-05 Catalyst 3560 Switch Command Reference 2-335