Cisco WS-X6148-GE-TX Hardware Installation Guide - Page 58
Installing an Expansion Module, Replacing or Installing Power Supplies - end of support
UPC - 746320802060
View all Cisco WS-X6148-GE-TX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Replacing or Installing Components Chapter 2 Installing the Cisco UCS 6100 Series Fabric Interconnect Send document comments to [email protected] Figure 2-13 Removing an Expansion Module From the Cisco UCS 6140XP 186598 Step 5 Step 6 Place the module on an antistatic mat or antistatic foam if not immediately reinstalling it in another slot. If you are not installing another expansion module in its place, install a filler panel (N10-SBLKE=) to keep dust out of the chassis and to maintain the designed airflow through the chassis. If you are installing a replacement expansion module, see Installing an Expansion Module, page 2-24. Installing an Expansion Module To install an expansion module, follow these steps: Step 1 Step 2 Step 3 Step 4 Ensure that the system (earth) ground connection has been made. For ground connection instructions, see the "Grounding the System" section on page 2-11. Grasp the handle of the module and place your other hand under the module to support it. Gently slide the module into the opening until you cannot push it any further. Tighten the captive screw on the front of the module. Replacing or Installing Power Supplies The Cisco UCS 6100 Series Fabric Interconnect supports two front-end power supplies, but may be used with one power supply. If you need to replace an existing power supply, follow the procedures that explain how to remove and install power supplies. If you are installing a new power supply where one did not exist before, follow the installation procedure. 2-24 Cisco UCS 6100 Series Fabric Interconnect Hardware Installation Guide OL-20036-02