Cisco WVC2300 Administration Guide - Page 39
Wired and Wireless Modes, Moving the Camera to Another Network, Installing the Camera Software - how to install and configure
UPC - 745883579617
View all Cisco WVC2300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Installing the Camera Software Wired and Wireless Modes 5 Wired and Wireless Modes NOTE This section applies to the Cisco WVC2300 camera. After the initial configuration, you can use the camera in one of two modes: wired or wireless. Verify the mode you are in by viewing the LEDs. You cannot use the camera in both modes simultaneously. To switch between wired and wireless modes, see "Moving the Camera to Another Network" on page 32. Moving the Camera to Another Network NOTE This section applies to the Cisco WVC2300 camera. When you move the camera from a wired network to a wireless network, or vice versa, you must power off the camera before connecting to the new network. To move the camera from a wired network to a wireless network, follow these steps: STEP 1 Unplug the power adapter from the camera. STEP 2 Unplug the Ethernet network cable from the camera. STEP 3 Re-connect the power adapter to the Power port on the camera. The camera's Ready LED flashes while the camera is initializing. The camera is ready for use when the Ready and Network LEDs are solidly lit. Cisco PVC2300 and WVC2300 Internet Video Cameras with Audio Administration Guide 32