Compaq ProLiant 3000 Compaq ProLiant Cluster HA/F100 and HA/F200 Administrator - Page 100
Upgrading the HA/F100 to an HA/F200, Preinstallation Overview
View all Compaq ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
4 Chapter Upgrading the HA/F100 to an HA/F200 Preinstallation Overview The difference between the Compaq ProLiant Cluster HA/F100 and the HA/F200 is the addition of a dual redundant loop. This redundant loop provides the HA/F200 cluster with no single points of failure in the connection between the servers and the storage subsytem(s). Adding this loop to an existing HA/F100 configuration requires the following: s One additional Compaq StorageWorks RA4000 Controller (array controller) per storage subsystem s One additional Compaq StorageWorks Fibre Channel Storage Hub s One additional Compaq StorageWorks Fibre Channel Host Adapter (host bus adapter) per server s Compaq Redundancy Manager (Fibre Channel) software s Appropriate firmware and drivers If you already have a Compaq ProLiant Cluster HA/F100 up and running, you do not need to repeat the installation of those hardware components described in Chapter 3. However, the upgrade from the HA/F100 to the HA/F200 will require the addition of the dual redundant loop hardware components, the Redundancy Manager software and updated Windows NT device drivers and firmware. These additional steps are described in Chapter 4.