Compaq ProLiant 3000 Compaq ProLiant Cluster HA/F100 and HA/F200 Administrator - Page 45
MSCS Configuration, Redundant Interconnect Card
View all Compaq ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
2-14 Compaq ProLiant Clusters HA/F100 and HA/F200 Administrator Guide MSCS Configuration MSCS allows you to configure a primary and backup path for intracluster communication, which will reduce the possibility of an intracluster communication disruption. Any network interface card (NIC) in the nodes can be configured to serve as a backup path for node-to-node communication. When the primary path is disrupted, the transfer of communication responsibilities goes undetected by applications running on the cluster. Whether a dedicated or public interconnect has been set up, a separate NIC should be configured to act as a redundant interconnect. This is an easy and inexpensive way to add redundancy to intracluster communication. Redundant Interconnect Card Another strategy to increase availability is to use a redundant interconnect card. This may be done for either the dedicated intracluster communication path, or for the client LAN. If you are using a dedicated, direct-connection interconnect configuration, you can install a second dedicated, direct-connection interconnect. NOTE: If you are using the ServerNet option as the interconnect, the card itself has a built-in level of redundancy. Each ServerNet PCI adapter has two data ports, thereby allowing two separate cables to be run to and from each cluster node. If the ServerNet adapter determines that data is being sent from one adapter but not received by the other, it will automatically route the information through its other port. There are two implementations that provide identical redundant NIC capability. The implementation you choose will depend on your hardware. The Compaq Redundant NIC Utility (originally called Advanced Network Fault Detection and Correction Feature) is supported on all Compaq TI-based Ethernet and Fast Ethernet NICs, such as NetFlex-3 and Netelligent 10/100 TX PCI Ethernet NICs. The Network Fault Tolerance feature is designed to operate with the Compaq Intel-based 10/100 NICs. Combining these utilities with the appropriate NICs will enable a seamless, undetectable failover of the primary interconnect to the redundant interconnect. NOTE: These two methods of NIC redundancy cannot be combined in a single redundant NIC pair: TI-based NICs may not be paired with Intel-based NICs to create a redundant pair. For more information, refer to the Compaq White Paper, "High Availability Options Supported by Compaq Network Interface Controllers," available at the Compaq High Availability website (http://www.compaq.com/highavailability).