Compaq ProLiant 3000 Compaq ProLiant Cluster HA/F100 and HA/F200 Administrator - Page 86
Installing the Software, Assisted Integration Using SmartStart (Recommended), Recommended
View all Compaq ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Setting Up the Compaq ProLiant Clusters HA/F100 and HA/F200 3-13 Installing the Software The following information describes the software installation steps for the HA/F100 and the HA/F200. Proceed with these steps once you have all equipment installed and your hubs, storage system, and one server powered up. You need the following during installation: IMPORTANT: Refer to Appendix C for the software and firmware version levels your cluster requires. s Compaq SmartStart for the Servers CD s Compaq SmartStart for Servers Setup Poster s Server Profile Diskette (included with SmartStart) s Microsoft Windows NT Server 4.0/Enterprise Edition software and documentation s Compaq Redundancy Manager (Fibre Channel) software s Monitoring and Management Software q Compaq Insight Manager software and documentation q Compaq Insight Manager XE software and documentation q Compaq Intelligent Cluster Administrator software and documentation s At least ten high-density diskettes s Windows NT 4.0 Service Packs Assisted Integration Using SmartStart (Recommended) Use the SmartStart Assisted Integration procedure to configure the servers (nodes) in the HA/F100 and HA/F200 configuration. You will set up two nodes during this process. Go through all steps on each of the nodes with noted exceptions. The following steps will take you through the SmartStart Assisted Integration procedure. CAUTION: Installation using SmartStart assumes that SmartStart is being installed on new servers. Any existing data on the servers' boot drive will be erased.