Craftsman 21513 Operation Manual - Page 5
Extension Cord Length - 1 3 hp electric belt disc sander
View all Craftsman 21513 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Extension Cord Length Wire Size A,W.G. Up to 25 ft 18 NOTE: Using extension cords over 25 ft. long is not recommended. MOTOR The sander is assembled with motor and wiring installed as an integral part of the tool. The electrical wiring schematic is shown in Figure 6. The permanently split capacitor motor has the following specifications: Horsepower (Maximum Developed 2/3 Voltage 120/240 Amps Hertz 3.5/1.75 60 Phase RPM Single 3500 Rotation (viewed from left side Clockwise ELECTRICAL CONNECTIONS WARNING: All electrical connections must be performed by a qualified electrician. Make sure tool is off and disconnected from power source while motor is mounted, connected, reconnected or anytime wiring is inspected. Motor and wires are installed as shown in wiring diagram (See Figure 6). Motor is assembled with approved, 3-conductor cord to be used at 120/240 volts. Motor is prewired at the factory for 120 volts. (.. l-Black ,) (_ 4-Yellow ) 3- e 120V 2-Gra ( l-Black _ 240V Figure 6 -Wiring Schematic To use the sander with a 240V power supply, have a qualified electrician rewire motor and attach a 240 volt, 15A three-prong plug onto sander line cord. The power lines are inserted directly onto the switch. The green ground line must remain securely fastened to the frame to properly protect against electrical shock. The power supply to the motor is controlled by a single pole locking rocker switch. • Remove the key to prevent unauthorized use. Refer to Figures 7-15. DESCRIPTION Craftsman 2 x 6" Belt and Disc Sander has a 2" x 42" belt and 6" disc for deburring, beveling and sanding wood, plastic and metal. The sander has a fan-cooled 2/3 HP maximum developed motor. Belt speed is 4400 FPM and the disc rotates 3500 RPM. The belt table tilts 0 to 90 ° and the disc table tilts 0 to 45 ° for angle sanding. The quick release tension and tracking mechanism makes belt changing quick and easy. Belt platen is removable for contour sanding. Belt housing swivels from vertical to horizontal for sanding large workpieces. Disc guard has 1'/2" dust collection chute. SPECIFICATIONS Belt size Belt platen area Belt table dimensions Belt table tilts 2 x 42", 80 grit 2 x 7'/," 9 x 63_" 0 to 90° Belt speed Disc diameter Disc table dimensions Disc table tilts Disc dust chute diameter 4400 FPM 6", 80 grit 81,4x 5W' 0 to 45 ° 1'/2" Disc speed Base dimensions 3500 RPM 81/,x 71/8" Switch SP, Locking rocker Weight 30 Ibs WARNING: Operation of any power tool can result in foreign objects being thrown into the eyes, which can result in severe eye damage. Always wear safety goggles complying with United States ANSI Z87.1 (shown on package) before commencing power tool operation. Safety goggles are available at Sears retail stores or catalog. CAUTION: Always observe following safety precautions. SAFETY PRECAUTIONS • Whenever adjusting or replacing any parts on the tool, turn switch OFF and remove the plug from power source. • Recheck table knobs. They must be tightened securely. • Make sure all guards are properly attached. All guards should be securely fastened. • Make sure all moving parts are free and clear of any interference. • Make sure all fasteners are tight and have not vibrated loose. • With power disconnected, test operation by hand for clearance and adjust if necessary, • Always wear eye protection or face shield. 5