Craftsman 21805 Operation Manual - Page 18

TO ASSEMBLE

THE

SLIDING

EXTENSION

TABLES

See

Figures 15- 16.

The rear

extension

rods are longer than the front

extension

rods and must be inserted into the plastic brackets under

the saw table first.

•

Locate the left sliding extension tabl- and slide the

extension rode into the plastic brackets under the saw

table,

•

Push the

extension

table until it rests against the saw

table and is completely closed.

•

Position the end plug (L)over the extension rod (the

side with the screw hole and detent facing out) and

slide into place,

•

Locate the left indicator.

NOTE: the indicators are cJearly marked with and

"R"

(right) or a "L" (left).

•

Thread the indicator (L) into the slot in the front rail.

Fit the top slot in the indicator over the detent and the

bottom slot over the screw hole.

•

Insert a screw into the bottom

slot

of the indicator, the

hole in the end plug and the extension rod, Finger-

tighten.

•

Insert the limit screw in the rear extension red

and

tighten,

•

Open

the

extension

table

completely.

When the

table

is

extended

fully,

the indicator

should stop

at 13 in.

•

Adjust

the indicator (left

or

right) so it

points to

the

13

in_

mark on the scale. Tighten the

screw.

Repeat the

above steps

for

the

right

sliding

extension

table with the

indicator

(R)

set

at 19 in. on the

right side.

LEFTSLIDING

EXTENSION

TABLE

RIGHTSLIDING

EXTENSION

TABLE_

ROD

END

PLUG

INDICATOR

(L)

Fig.

15

SCREW

INDICATOR(L)

Fig,

16

18

Craftsman 21805 Operation Manual - Page 18

To Assemble

Page 18 highlights