Craftsman 21805 Operation Manual - Page 38

Saw does not make aCCurate 90" or 45" Outs. I Height/bevel adjusting handwheel is hard to turn. Sew does not start. m Blade makes poor cuts. Blade does not lower when turning height/bevel adjusting handwheel. Motor labors in rip cut. ] Positive stops inside cabinet need adjusting (Bevel Cuts). Miter gauge is rnisaligned (Miter Cuts). Gears or screw post inside cabinet ere clogged with saw dust. Motor cord or wall cord is not plugged in, Circuitfuse is blown. Circuit breaker is tripped. Cord or switch is damaged. Adjust positive stops. Adjust the miter gauge, HHn • n Clean the gears or screw post. • •nn Plug in motor cord or wall cord. Replace circuit fuse. Reset circuit breake[ Have the cord or switch replaced at your Sears Service Center. Blade is dull or dirty. Blade is wrong type for cut being made, Blade is mounted backwards. Locking lever is not at full left position. Clean, sharpen, or replace blade, Replace with correct type. Remount blade. Move locking Feverto left_ Blade not proper for rip cut. Change blade; rip blade typically has fewer teeth. 38