Craftsman 28129 Operation Manual - Page 6

WARNING: Your tool should NEVER be connected to the power source when you are assembling parts, making adjustments, installing or removing bits, cleaning or when it is not in use. Disconnecting the drill will prevent accidental starting, which could cause serious personal injury. 1. Remove the hammer drill from the storage / carry case and inspect it carefully to make sure that no breakage or damage has occurred during shipping. 2. Do not discard any of the packing materials until all parts are accounted for. 3. Included with this hammer drill is an auxiliary handle, a depth stop rod, and a chuck key. 4. If any of the parts are damaged or missing (refer to PARTS LIST below), return the saw to your nearest Sears store or Craftsman outlet to have the tool replaced. ,_ WARNING: If any parts are missing, DO NOT operate this tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury. PARTS LIST (Fig. 1) 1. Hammer Drill [ 3. Depth Stop Rod 4. Chuck Key 5. Carrying / Storage Case 6. Operator's Manual z_ WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. 10 KNOWYOUR HAMMER DRILL (Fig. 2) NOTE: Before attempting to use this product, familiarize yourself with all operating features and safety rules. Your Hammer Drill has a precision-built electric motor and it should be connected to a 120-volt, 60-Hz AC ONLY power supply (normal household current). DO NOT operate on direct current (DC). The large voltage drop will cause a loss of power and the motor will overheat. If the drill does not operate when plugged into correct 120-volt, 60-Hz AC ONLY outlet, check the power supply. This hammer drill has a 10-ft., 2-wire power cord (no adapter needed). This Hammer Drill has the following features: 1.8.0 Amp Motor Provides torque, power and durability to handle continuous heavy-duty rotary or hammer drilling jobs 2. Mode Selector Switch For easy changes to rotary or hammer drilling applications 3. Rotary Drilling Variable speed 0-2800 / min (no-load speed) allows matching drilling / driving speed to bits and materials in a variety of job applications such as hard or soft woods, metal and various building materials. 4. Forward / Reverse Lever Conveniently located, reverse to back out screws and jammed bits when rotary drilling / driving 5. Hammer Drilling Variable speed 0-44,800 BPM (blows per minute) impact rate, for fast drilling in concrete, brick, stone and tile 6. Variable Speed Trigger Switch Controls speed, increase pressure for higher speed and torque 7. Power Lock-on Button For use in continuous stationary hammer drilling applications 8. 1/2-in. Keyed Steel Chuck Tighten bits quickly and securely with chuck key and spindle lock 9. Spindle Lock Manually lock chuck's spindle shaft for safe, secure tightening of bits in chuck 10. 360 ° Auxiliary Handle and Rear Handle with Soft-Grip Provides maximum balance, control and gripping comfort. Auxiliary handle mounts in any position for left or right hand use 11. Depth Stop Rod Mounts in auxiliary handle and adjusts for precise pre-set drilling depths 12. Bubble Level Helps provide more accurate right angle drilling/driving and hammer drilling straight into workpiece 13. Live Tool indicator Green LED light lets you know when drill is plugged into power source 11