Craftsman 28195 Product Manual - Page 26

0 ° BEVEL STOP The saw has a 0 ° bevel stop that has been factory adjusted to assure a 0° angle of the saw blade when making 90°cuts. TO CHECK 0° BEVEL STOP ,_ WARNING: Always unplug the saw before making any adjustments. Failure to unplug the saw could result in accidental starting, which can cause serious personal injury. 1. Unplug the saw from the power source. 2. Place the saw in an upside-down position on a workbench. 3. Using a carpenter's square, check that the saw blade is square to the base of the saw (Fig 16). TO ADJUST 0° BEVEL STOP (Fig. 17) 1. Unplug the saw from the power source. 2. Loosen the beveladjustment knob. 3. Locate the 0° bevel-stop adjusting screw 4. Using a hex key, turn the 0 ° bevel-stop adjusting screw until it is square with the saw blade. Fig. 16 Fig. 17 0° bevel-stop adjusting screw 0 ° bevel stop ustment screw MAKING POCKET CUTS WARNING: Always adjust the bevel setting to zero before making a pocket cut. Attempting a pocket-cut at any other setting can result in a loss of control of the saw, which can result in serious injury. 1. Adjust the bevel setting to zero, set the blade to the correct blade depth setting, then use the lower blade guard lever to swing the guard up. ,_ WARNING: Always use the lever to raise the lower blade guard to avoid serious injury. 28195 Manual_Revised_07-0623 Page 26