Craftsman 28195 Product Manual - Page 9

SAFETY SYMBOLS FOR YOUR TOOL The label on your tool may include the following symbols. V Volts A Hz Amps Hertz W min Watts Minutes Alternating current Direct current no No-load speed min Class II construction, Double Insulated Revolutions or Strokes per minute Indicates danger, warning or caution. It means attention! Your safety is involved. SERVICE SAFETY If any part of this saw is missing or should break, bend, or fail in any way, or should any electrical component fail to perform properly: shut off the power switch, remove the saw plug from the power source, and have the missing, damaged or failed parts replaced before resuming operation. • Tool service must be performed only at a Sears Parts and Repair Center. Service or maintenance performed by unqualified personnel could result in a risk of injury. • When servicing a tool, use only identical replacement parts. Follow instructions in the maintenance section of this manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury. SAFETY RULES FOR HYPOID CIRCULAR SAWS ,_ DANGER: Keep hands away from cutting area and blade. Keep your second hand on the auxiliary handle or motor housing. If both hands are holding the saw, the blade cannot cut them. Do not position your body in direct line with the saw blade; position your body to either side of the saw blade. Kickback could cause the saw to jump backwards. (See "Kickback--What Causes It and Ways to Help Prevent It" in the Operation section of this manual.) DO NOT reach underneath the work. The guard cannot protect you from the portion of the blade that is beneath the workpiece. 28:$95 Manual_Revised_07-0623 Page 9