Craftsman 28945 Operation Manual - Page 27
Drive, Mower, Belt Removal, Belt Installation, To Replace, Belt Removal
View all Craftsman 28945 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
TO REPLACE MOWER DRIVE BELT MOWER DRIVE BELT REMOVAL 1. Park tractor on a level surface. Engage parking brake. 2. Lower attachment lift lever to its lowest position. 3. Disengage belt tension rod (K) from lock d_llbracket (L). AUTION: Belttension rod is spring loaded. Have afirm grip on rod and release slowly. 4. Remove screws (P) from R.H. and LH. mandrel covers and remove covers (Q). 5. Remove anydirt orgrass clippings which may have accumulated around mandrels and entire upper deck surface. 6. Remove belt from electric clutch pulley (M), both mandrel pulleys (R) and all idler pulleys (S). MOWER DRIVE BELT INSTALLATION 1. Install belt around both mandrel pulleys (R) and around idler pulleys (S) as shown. 2. Install belt onto electric clutch pulley (M). IMPORTANT: Check belt for proper routing in all mower pulley grooves. 3. Reassemble R.H. and LH. mandrel cov- ers (Q). Securely tighten all screws. 4. Engage belt tension rod (K) on locking bracket (L). _, CAUTION: Belt tension rod is spring load- ed. Have atight grip on rod and engage slowly. 5. Raise attachment position. lift lever to highest BELT REMOVAL- 1. Remove mower (See "TO REMOVE MOWER" in this section of manual). NOTE: Observe entire motion drive belt and position of all belt guides and keepers. 2. Disconnect clutch wire harness (A). 3. Remove anti-rotation link (B) on right side of tractor. 4. Remove belt from stationary idler (C) and clutching idler (D). 5. Remove belt from centerspan idler (E). 6. Pull belt slack toward rear of tractor. Remove belt upwards from transaxle input pulley (F). 7. Remove belt downward from engine pulley and around electric clutch (G). 8. Slide belt toward rear of tractor, off the steering plate (H) and remove from tractor. BELT INSTALLATION - 1. Install new belt from tractor rear to front, over the steering plate (H) and above clutch brake pedal shaft (J). 2. Pull belt toward front of tractor and roll belt around electric clutch and onto engine pulley (G). 3. Pull belt toward rear of tractor. Care- fully work belt down around transaxle input pulley (F). Be sure belt is inside the belt keeper. 4. Install belt on centerspan idler (E). 5. Install belt through stationary idler (C) and clutching idler (D). 6. Reinstall anti-rotation link (B) on right side of tractor. Tighten securely. 7. Reconnect clutch harness (A). 8. Make sure belt is in all pulley grooves and inside all belt guides and keepers. 9. Install mower (See "TO INSTALL MOWER" in this section of manual). TO REPLACE MOTION DRIVE BELT Park the tractor parking brake. belt installation of left footrest. on level surface. Engage For assistance, there is a guide decal on bottom side 27