Cub Cadet SCP21E Operation Manual - Page 11

ASSEMBLY AND SET-UP NOTE: Reference to right and left hand side of the Lawn Mower is observed from the operating position. Unpacking OPENING CARTON 1. Cut each corner of the carton vertically from top to bottom. 2. Remove all loose parts: • Grass Catcher (if equipped) • Battery (if equipped) • Battery Charger (if equipped) 3. Remove loose packing material. REMOVING MOWER FROM CARTON 1. Lift mower from the rear to detach it from underlying carton material and roll mower out of carton. 2. Check carton thoroughly for any other loose parts. 3. Remove any packing material which may be between upper and lower handles. Assembly CHARGE BATTERIES 1. Charge battery. Refer to Charging a Battery on page 9. HANDLE ASSEMBLY 1. Loosen the wing knob securing the left side upper and lower handle together shown in Figure 3 inset. 2. Remove the packaging with wing knob and bolt Securing the right side upper and lower handles together. 3. Gently lift and pivot the upper handle into the position shown in Figure 3. 5. Securely tighten the wing knobs to secure the upper handle to the lower handle. 6. Rotate the handle adjustment levers to release the handle adjustment pins from the handle bracket. See Figure 4 insets. 2 1 2 1 Figure 4 7. Carefully lift the handle up. 8. Place the handle into one of the three handle height positions, high (a), medium (b) or low (c), located on the handle brackets (Figure 5). 2 1 Figure 3 4. Insert bolt through the right side lower and upper handle. Thread wing knob onto bolt. See Figure 3 inset. a b c Figure 5 9. Rotate the handle adjustment levers until they are parallel with the handle to lock the pins into one of the handle height positions in the handle brackets (Figure 5). 11