Cub Cadet SCP21E Operation Manual - Page 15

Operation

Page 15 highlights

OPERATION Operation USING YOUR LAWN MOWER WARNING The operation of any lawn mower can result in foreign objects being thrown by the blade. Always wear safety glasses while operating the mower, or while performing any adjustments or repairs. Be sure lawn is clear of stones, sticks, wire, or other objects which could damage mower or be thrown by the blade in any direction and cause serious injury to the operator, others, or the equipment. DO NOT use mower in the rain. For a healthy lawn, always cut off one-third or less of the total length of the grass. STARTING MOTOR WARNING Avoid accidental starting. Make sure you are in the operating position behind the mower when using it. To avoid serious injury, the operator and mower should be in a stable position while starting. Insert the push start safety key into the starter housing located in the center of upper handle until it snaps in place. 1. Standing behind the mower, pull the blade control back against the upper handle (Figure 13). Figure 13 2. Press the push start safety key to start the motor. STOPPING MOTOR 1. Release the blade control to stop the motor and blade. WARNING The blade continues to rotate for up to three (3) seconds after the motor is shut off. If motor does not stop within three (3) when the blade control is released, remove the push start safety key and contact an authorized service dealer. 2. Remove the push start safety key if mower is to be left unattended, stored, or serviced. Keep the push start safety key in a safe place out of the reach of children. USING GRASS CATCHER To collect clippings while you are operating the mower. 1. Attach grass catcher. Refer to Grass Catcher on page 12. Grass clippings will automatically collect in bag as you run mower. Operate mower until grass bag is full. 2. Stop motor completely by releasing the blade control handle. Make sure that the blade has come to a complete stop before removing the grass catcher. 3. Lift discharge door and pull grass bag up and away from the mower. Dispose of the grass clippings and reinstall the bag when complete. WARNING If you strike a foreign object, stop the motor. Thoroughly inspect mower for any damage, and repair damage before restarting and operating. Excessive vibration of mower during operation is an indication of damage. The mower should be promptly inspected and repaired. USING AS MULCHER Remove the side discharge chute or grass catcher and allow the rear discharge door to close. For effective mulching, do not cut wet grass. If the grass has been allowed to grow in excess of four inches, mulching is not recommended. Use the grass catcher to bag clippings instead. USING SIDE DISCHARGE Attach the side discharge. Refer to Side Discharge Chute/Mulch Plug on page 12. When using the side discharge, the most effective mowing pattern is one that allows the clippings to discharge towards the uncut part of the lawn. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56

15
OPERATION
STOPPING MOTOR
1.
Release the blade control to stop the motor and blade.
WARNING
The blade continues to rotate for up to three (3) seconds
after the motor is shut off. If motor does not stop within
three (3)
when the blade control is released, remove the
push start safety key and contact an authorized service
dealer.
2.
Remove the push start safety key if mower is to be left
unattended, stored, or serviced. Keep the push start safety
key in a safe place out of the reach of children.
USING GRASS CATCHER
To collect clippings while you are operating the mower.
1.
Attach grass catcher. Refer to Grass Catcher on page 12.
Grass clippings will automatically collect in bag as you run
mower. Operate mower until grass bag is full.
2.
Stop motor completely by releasing the blade control handle.
Make sure that the blade has come to a complete stop before
removing the grass catcher.
3.
Lift discharge door and pull grass bag up and away from the
mower. Dispose of the grass clippings and reinstall the bag
when complete.
WARNING
If you strike a foreign object, stop the motor. Thoroughly
inspect mower for any damage, and repair damage
before restarting and operating. Excessive vibration of
mower during operation is an indication of damage. The
mower should be promptly inspected and repaired.
USING AS MULCHER
Remove the side discharge chute or grass catcher and allow the
rear discharge door to close.
For effective mulching, do not cut
wet grass. If the grass has been allowed to grow in excess of four
inches, mulching is not recommended. Use the grass catcher to
bag clippings instead.
USING SIDE DISCHARGE
Attach the side discharge. Refer to Side Discharge Chute/Mulch
Plug on page 12. When using the side discharge, the most
effective mowing pattern is one that allows the clippings to
discharge towards the uncut part of the lawn.
Operation
USING YOUR LAWN MOWER
WARNING
The operation of any lawn mower can result in foreign
objects being thrown by the blade. Always wear safety
glasses while operating the mower, or while performing
any adjustments or repairs.
Be sure lawn is clear of stones, sticks, wire, or other objects
which could damage mower or be thrown by the blade in any
direction and cause serious injury to the operator, others, or the
equipment.
DO NOT use mower in the rain.
For a healthy lawn, always cut off one-third or less of the total
length of the grass.
STARTING MOTOR
WARNING
Avoid accidental starting. Make sure you are in the
operating position behind the mower when using it. To
avoid serious injury, the operator and mower should be in
a stable position while starting.
Insert the push start safety key into the starter housing located
in the center of upper handle until it snaps in place.
1.
Standing behind the mower, pull the blade control back
against the upper handle (Figure 13).
Figure 13
2.
Press the push start safety key to start the motor.