Cub Cadet SCP21E Operation Manual - Page 13
Cub Cadet SCP21E Manual
View all Cub Cadet SCP21E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ASSEMBLY AND SET-UP CUTTING HEIGHT The cutting height adjustment lever is located above the front and rear left wheel. 1. Pull the cutting height adjustment lever towards wheel. 2. Move lever to desired position for a change in cutting height (Figure 10). INSTALLING BATTERY IMPORTANT: Use only with series CC6050 or CC6025 batteries. 1. Lift up the battery housing lid. 2. Slide one battery (a) into right side battery port (b) (as standing in front of mower) so that the battery indicator light faces up from the battery port (Figure 11). 3. Push the battery firmly until the battery locks into place. There should be an audible "click" when the battery is in position. Figure 10 IMPORTANT: Both the front and rear wheels must be placed in the same relative position. For rough or uneven lawns, move the height adjustment levers to a higher position. This will stop scalping of grass. 3. Release lever towards deck. WARNING Do not at any time make any adjustment to lawn mower without first stopping motor and removing push start safety key. a b c Figure 11 4. Repeat STEPS 2 and 3 to install a second battery (available separately) into the left side battery storage port (c). NOTE: Left side battery storage port is for storing a second battery. This port is not used to power the mower. 5. Close battery housing lid. 13