Cuisinart SS-10P1 User Manual - Page 12

Brewing with the HomeBarista™ Reusable Filter Cup (included) The Cuisinart® Premium Single-Serve Coffeemaker can be used with a Reusable Filter Cup, which allows you to use your own ground coffee. The dishwasher-safe, capsule conveniently stores in the easy-open compartment. 1. Open the storage compartment located on the right side of the coffeemaker by pressing the finger indent. Remove the HomeBarista™ Reusable Filter Cup (see figure 11). 6. Open brew head. Remove the capsule holder from the brewing chamber by pulling up. (If you would like, store the capsule holder in the HomeBarista™ storage compartment.) 7. Drop the assembled HomeBarista™ into the brewing chamber. (No need to snap it into place). See figure 12. HomeBarista™ Reusable Filter Cup Lid Filter Basket Filter Cup figure 11 2. Disassemble the HomeBarista™ by locating the tab on the front of capsule and pushing up. Remove the filter basket from the filter cup (see figure 11). 3. Wash the HomeBarista™, filter basket and filter cup in warm, soapy water prior to use, making sure to rinse and dry thoroughly. All HomeBarista™ parts are dishwasher safe. 4. Insert the filter basket into the filter cup. 5. Fill the filter basket with ground coffee, making sure not to fill past the top of the mesh. Adjust the amount to your personal preference. Do not tamp the grinds. Ensure there are no grinds remaining on the upper rim of the filter basket. Push lid down until top tab latches with bottom tab. Note: Use medium grind as a fine grind may cause capsule to overflow. Max fill = 2½ tbsp. (15g) figure 12 CAUTION: There are two sharp needles that puncture the capsule, one above and one below. To avoid risk of injury, do not put your fingers in the capsule brewing chamber. 8. Follow Brewing instructions on page 9. 9. Following brewing, raise the handle and remove the HomeBarista™. Use caution as it will be hot. 10. Open HomeBarista™. Remove the filter basket from the holder, discard the grounds and rinse out the filter basket and holder. 11. Replace the capsule holder, ensuring the arrow on capsule rim aligns with the arrow on the brewing chamber. Gently push the capsule holder to snap into place (see figure 13). figure 13 12