Cuisinart SS-10P1 User Manual - Page 17

Cleaning & Maintenance

Get Cuisinart SS-10P1 PDF manuals and user guides View all Cuisinart SS-10P1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Cleaning & Maintenance Cleaning External Parts We recommend regular cleaning of the coffeemaker's external components. 1. Never immerse the coffeemaker in water or other liquids. The housing and other external components may be cleaned with a soapy, damp, non-abrasive cloth. 2. To remove the drip tray, simply lift it up keeping it level at all times in order to prevent spills. The drip tray and drip tray plate are dishwasher safe. Cleaning the Cuisinart HomeBarista™ Reusable Filter Cup 1. Open the storage compartment located on the right side of the coffeemaker by pressing the finger indent. Remove the HomeBarista™. 2. Disassemble the HomeBarista™ by locating tab on front of capsule and pushing up. Remove the filter basket from the holder (see figure 23). 3. Wash the HomeBarista™ filter basket and holder in warm, soapy water, making sure to rinse and dry thoroughly. HomeBarista™ parts are dishwasher safe. Cleaning the Capsule Holder CAUTION: There are sharp needles that puncture the capsule above and below. To avoid risk of injury, do not put your fingers in the capsule brewing chamber. 1. The capsule holder is top-shelf dishwasher safe (use low temperature cycles). To remove, lift the handle to open the brewing chamber. Grasp the top of the capsule holder and pull up. 2. Cleaning the Funnel To remove funnel from capsule holder, hold funnel in left hand, twist bottom away from you slightly and pull away from capsule holder to remove. The funnel is top-rack dishwasher safe. figure 24 Note: The funnel may be tight the first few times you go to remove it, this is normal and will loosen with continued use. 3. Cleaning the Exit Needle The exit needle is located on the inside bottom of the capsule holder assembly. Should a clog arise because of coffee grounds, it can be cleaned using a paper clip or similar tool. Remove capsule holder from unit, then remove funnel from capsule holder and insert the paper clip into exit needle to loosen the clog and push it out (Figure 25). figure 23 figure 25 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
figure 23
figure 24
figure 25
17
Cleaning & Maintenance
Cleaning External Parts
We recommend regular cleaning of the
coffeemaker’s external components.
1. Never immerse the coffeemaker in
water or other liquids. The housing
and other external components may
be cleaned with a soapy, damp,
non-abrasive cloth.
2. To remove the drip tray, simply lift it up
keeping it level at all times in order to
prevent spills. The drip tray and drip tray
plate are dishwasher safe.
Cleaning the Cuisinart
HomeBarista
™
Reusable
Filter Cup
1. Open the storage compartment located
on the right side of the coffeemaker by
pressing the finger indent. Remove the
HomeBarista
™
.
2. Disassemble the HomeBarista
™
by
locating tab on front of capsule and
pushing up. Remove the filter basket
from the holder (see figure 23).
3. Wash the HomeBarista
™
filter basket
and holder in warm, soapy water,
making sure to rinse and dry thoroughly.
HomeBarista
™
parts are dishwasher safe.
Cleaning the Capsule Holder
CAUTION: There are sharp needles
that puncture the capsule above and
below. To avoid risk of injury, do not
put your fingers in the capsule
brewing chamber.
1. The capsule holder is top-shelf
dishwasher safe (use low temperature
cycles). To remove, lift the handle to
open the brewing chamber. Grasp the
top of the capsule holder and pull up.
2.
Cleaning the Funnel
To remove funnel from capsule holder,
hold funnel in left hand, twist bottom
away from you slightly and pull away from
capsule holder to remove. The funnel is
top-rack dishwasher safe.
Note:
The funnel may be tight the first
few times you go to remove it, this is
normal and will loosen with continued use.
3.
Cleaning the Exit Needle
The exit needle is located on the inside
bottom of the capsule holder assembly.
Should a clog arise because of coffee
grounds, it can be cleaned using a paper
clip or similar tool. Remove capsule
holder from unit, then remove funnel
from capsule holder and insert the paper
clip into exit needle to loosen the clog
and push it out (Figure 25).