D-Link DGS-1520-28MP Product Manual 1 - Page 24

CAUTION, ATTENTION, DGS-1520-28MP, feature a 22-pin RPS port on the back panel.

Get D-Link DGS-1520-28MP PDF manuals and user guides View all D-Link DGS-1520-28MP manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

DGS-1520 Series Gigabit Ethernet Smart Managed Switch Hardware Installation Guide A green LED on the front panel of the RPS will be on to indicate a successful connection. Reconnect the AC power cord to the AC power port of the Switch. The RPS LED indicator on the front panel of the Switch will indicate that an RPS is present and now in operation. No software configuration is required. CAUTION: Leave at least 15 cm (6 inches) of space at the rear of the Switch when an RPS is installed to prevent cable damage. ATTENTION: Laissez un espace d'au moins 15 cm (6 pouces) à l'arrière du commutateur lorsqu'un RPS est installé pour éviter d'endommager les câbles. NOTE: Only the DGS-1520-28MP and DGS-1520-52MP feature a 22-pin RPS port on the back panel. Always keep the RPS port cover installed when there is no RPS connected to the Switch. Figure 3-13 Reinstalling the RPS port cover (when no RPS is connected) 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
DGS-1520 Series Gigabit Ethernet Smart Managed Switch Hardware Installation Guide
19
A green LED on the front panel of the RPS will be on to indicate a successful connection. Reconnect the AC power
cord to the AC power port of the Switch. The RPS LED indicator on the front panel of the Switch will indicate that an
RPS is present and now in operation. No software configuration is required.
CAUTION:
Leave at least 15 cm (6 inches) of space at the rear of the Switch when an RPS is installed
to prevent cable damage.
ATTENTION:
Laissez un espace d’au moins 15 cm (6 pouces) à l'arrière du commutateur lorsqu'un RPS
est installé pour éviter d'endommager les câbles.
NOTE:
Only the
DGS-1520-28MP
and
DGS-1520-52MP
feature a 22-pin RPS port on the back panel.
Always
keep the RPS port cover installed when there is no RPS connected to the Switch.
Figure 3-13 Reinstalling the RPS port cover (when no RPS is connected)