D-Link DGS-3130 Quick Install Guide - Page 2
DGS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide, SFP Mini-GBIC, XENPAK - d link
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
DGS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide Information in this document is subject to change without notice. Reproduction in any manner whatsoever, without the written permission of D-Link Corporation, is strictly forbidden. Trademarks used in this text: D-Link and the D-LINK logo are trademarks of D-Link Corporation; Microsoft and Windows are registered trademarks of Microsoft Corporation. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. D-Link Corporation disclaims any proprietary interest in trademarks and trade names other than its own. © 2017 D-Link Corporation. All rights reserved. FCC Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his expense. CE Mark Warning This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment may cause radio interference. VCCI Warning A VCCI-A. BSMI Notice Safety Compliance Warning: Class 1 Laser Product: Product shall be used with Class 1 laser device modules certified by CDRH. Le produit peut être utilisé avec des modules de dispositifs laser de classe 1 certifiés par le CDRH. • EN: When using a fiber optic media expansion module, never look at the transmit laser while it is powered on. Also, never look directly at the fiber TX port and fiber cable ends when they are powered on. • FR: Ne regardez jamais le laser tant qu'il est sous tension. Ne regardez jamais directement le port TX (Tramsmission) à fibres optiques et les embouts de câbles à fibres optiques tant qu'ils sont sous tension. SFP (Mini-GBIC), XENPAK, and XFP Regulatory Compliance Networks pluggable optical modules should meet the following regulatory requirements: • Class 1. • IEC/EN60825-1:2007 2nd Edition or later, European Standard • FCC 21 CFR Chapter 1, Subchapter J in accordance with FDA and CDRH requirements. • Application of CE Mark in accordance with 2004/108/EEC EMC Directive and the 2006/95/EC Low Voltage Directives. • UL and/or CSA registered component for North America. • 47 CFR Part 15, Class A when installed into products. Warning Class I Equipment. This equipment must be earthed. The power plug must be connected to a properly wired earth ground socket outlet. An improperly wired socket outlet could place hazardous voltages on accessible metal parts. Avertissement Équipement de classe I. Ce matériel doit être relié à la terre. La fiche d'alimentation doit être raccordée à une prise de terre correctement câblée. Une prise de courant mal câblée pourrait induire des tensions dangereuses sur des parties métalliques accessibles. ii