D-Link DGS-3130 Quick Install Guide - Page 38

See the RPS Quick Installation Guide for more information., Redundant Power Supply unit.

Get D-Link DGS-3130 PDF manuals and user guides View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

DGS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide Figure 3-13 Front view of the DPS-700 1. Insert one end of the 22-pin DC power cable into the receptacle on the Switch and the other end into the Redundant Power Supply unit. 2. Using a standard AC power cable, connect the redundant power supply to the main AC power source. A green LED on the front of the DPS-700 will glow to indicate a successful connection. 3. Re-connect the Switch to the AC power source. The LED indicator will show that a redundant power supply is now in operation. 4. No configuration in the Switch's firmware is needed for this installation. NOTE: See the RPS Quick Installation Guide for more information. CAUTION: This equipment is to be connected only to PoE networks without routing to the outside plant. 38

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
DGS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
38
Figure 3–13 Front view of the DPS-700
1.
Insert one end of the 22-pin DC power cable into the receptacle on the Switch and the other end into the
Redundant Power Supply unit.
2.
Using a standard AC power cable, connect the redundant power supply to the main AC power source. A
green LED on the front of the DPS-700 will glow to indicate a successful connection.
3.
Re-connect the Switch to the AC power source. The LED indicator will show that a redundant power supply is
now in operation.
4.
No configuration in the Switch’s firmware is needed for this installation.
NOTE:
See the RPS Quick Installation Guide for more information.
CAUTION:
This equipment is to be connected only to PoE networks without routing to the
outside plant.