D-Link DGS-3208TG User Guide - Page 14
Features, Ports, Performance features
UPC - 790069239366
View all D-Link DGS-3208TG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Gigabit Ethernet Switch User's Guide segments. This allows the total network capacity to be multiplied, while still maintaining the same network cabling and adapter cards. Switching LAN technology is a marked improvement over the previous generation of network bridges, which were characterized by higher latencies. Routers have also been used to segment local area networks, but the cost of a router and the setup and maintenance required make routers relatively impractical. Today's switches are an ideal solution to most kinds of local area network congestion problems. Features The DGS-3208TG Gigabit Ethernet Switch was designed for easy installation and high performance in an environment where traffic on the network and the number of users increase continuously. Switch features include: Ports ♦ Six 100BASE-TX/1000BASE-T (Fast Ethernet/Gigabit Ethernet) ports with cable-ready RJ-45 jacks. ♦ Two GBIC (Gigabit Interface Converter) slots, able to accommodate GBICs for all standard Gigabit Ethernet cabling. ♦ RS-232 DCE console port for diagnosing the Switch via a connection to a PC and console/out-of-band management. Performance features ♦ Store and forward switching scheme capability to support rate adaptation and protocol conversion. ♦ Full duplex to allow two communicating stations to transmit and receive at the same time. ♦ Data forwarding rate 1,488,100 pps per port at 100% of wire-speed for 1000-Mbps speed. ♦ Data filtering rate eliminates all error packets, runts, etc. at 1,488,100 pps per port at 100% of wire- speed for 1000-Mbps speed. ♦ 12K active MAC address entry table per device with automatic learning and aging. ♦ 16 MB packet buffer per device. ♦ Supports broadcast storm rate filtering. ♦ Supports IGMP snooping. ♦ Supports port mirroring. ♦ Supports GVRP. ♦ Supports GMRP (802.1P). ♦ Supports 802.1P priority (tag mode). ♦ Supports static filtering (based on MAC Address) 2