D-Link DGS-3620-52T-SI Product Manual - Page 244
BGP Aggregate Address Settings, BGP Network Settings
View all D-Link DGS-3620-52T-SI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 244 highlights
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide Keepalive Time (0-65535) The valid values are from 0 to 65535. This specifies the interval at which keepalive messages are sent to its peer. If the keepalive value is set to zero, then the keepalive message will not be sent out. The default value is 60 seconds. If the two routers that build a BGP connection have a different keepalive timer, then the smaller keepalive timer will be used. If the timer is specified for specific neighbors, then the neighbor specific timer will take effect. Scan Timer (5-60) Enter the BGP scan timer value from 5 to 60 seconds or tick the Default check box. The default value is 60 seconds. Fast External Fallover Enable or disable fast external fallover. This configures a Border Gateway Protocol (BGP) routing process to immediately reset its external BGP peer sessions if the link used to reach these peers goes down. The default state is Enabled. Aggregate Next Hop Check Enable or disable aggregate next hop check. This is used to configure the BGP aggregated routes' next hop check. Only the routes with the same next hop attribute can be aggregated if the BGP aggregate next hop check is Enabled. The default state is Disabled. Click the Apply button to accept the changes made for each individual section. BGP Aggregate Address Settings This window is used to create an aggregate entry in the Border Gateway Protocol (BGP) database. To view the following window, click L3 Features > BGP > BGP Aggregate Address Settings, as shown below: Figure 5-114 BGP Aggregate Address Settings window The fields that can be configured are described below: Parameter Description IP Address Enter the IP network address to be aggregated. Netmask Enter the netmask of the IP network address to be aggregated. Summary Only Tick this check box to stop more specific routes from being advertised. The default setting is un-ticked. AS Set Tick this check box to generate Autonomous System set path information. The default setting is un-ticked. Click the Add button to add a new entry based on the information entered. Click the Find button to locate a specific entry based on the information entered. Click the Delete All button to remove all the entries listed. Click the View All button to display all the existing entries. Click the Delete button to remove the specific entry. BGP Network Settings This window is used to specify the network advertised by the Border Gateway Protocol (BGP). 234