D-Link DSN-3400-10 Hardware Reference Guide for DSN-3200-10 Valid for fir - Page 27

3.7 Powering-on the DSN-3000 series Storage System To power-on the DSN-3000 series storage system, press the power switch on the back panel. When the DSN-3000 series storage system powers-on, the following actions occur:  The DSN-3000 series storage system Power LED turns green (see Figure 2-1).  The DSN-3000 series storage system runs its power-on procedure (~4 minutes), then the Ready/Fault LED turns green and drive LEDs may flash. The completion of the power-on process can be verified as indicated in Table 3-2. Table 3-2. Verifying Completion of the DSN-3000 Series Storage System Power-on Process If the DSN-3000 series Storage System... Has no front panel Ready/Fault LED Has a front panel Ready/Fault LED. Diagnostic port is connected to a PC via a diagnostic cable. Verify the Power-on Process by... Wait five minutes after powering-on the DSN-3000 series storage system. The LED turns green when the startup process completes. If the LED turns red, reboot the DSN-3000 series storage system. If the problem persists, contact Technical Support. The message RCP sequence complete appears on the PC monitor. After verifying this message, disconnect the PC from the diagnostic port. After the DSN-3000 series storage system powers-on for the first time, it automatically loads the factory-default configuration settings. If necessary, you can use the xStack Storage Management Center to change these settings to suit your requirements. DSN-3000 series Hardware Reference Guide 27