DELPHI NA10000-11B1 User Manual - Page 11
Installing Delphi, Mobile Navigation In Your Vehicle - gps
UPC - 689604150672
View all DELPHI NA10000-11B1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
SECTION 4: INSTALLING DELPHI MOBILE NAVIGATION IN YOUR VEHICLE Warning: To avoid personal injury, follow the safety guidelines and installation instructions provided so that Delphi Mobile Navigation does not obstruct the view of the driver, interfere with the operation of any airbags and safety features in the vehicle, or become airborne in the case of an accident. Do not attempt to install the Delphi Mobile Navigation unit while driving. Before installing Delphi Mobile Navigation, check whether your vehicle is fitted with a heat-reflecting or heated windshield. If so, you will need to purchase an external antenna from your retailer to allow your unit to pick up the GPS signals. The Delphi Mobile Navigation unit can be mounted three different ways: 1. Suction onto the windshield 2. To the dash by suction or adhesive tape 3. Screw onto the dash Note: Alternative mounting options may be available for your vehicle make and model. Contact your retailer or Delphi for more information. Caution: To avoid overheating of the unit, do not leave your Delphi Mobile Navigation on the dash or windshield while your vehicle is unattended, especially in strong sunlight. Do not use or handle Delphi Mobile Navigation while it is hot. Let it cool away from heat sources before handling it. If the unit becomes hot, it prompts you to turn down the brightness (press and hold the "Zoom" key). If the unit becomes too hot, the screen will go blank and voice instructions will continue. Suction mount to windshield 1. Choose a position on the windshield where Delphi Mobile Navigation will be clearly visible by the driver without obstructing the driver's view. Mount low on the windshield, as close to the dash as possible. 2. Thoroughly clean and dry the suction cup and the mounting area of the windshield. 3. Hold the suction cup firmly against the windshield and press the lever down until it snaps shut. To remove the suction cup, pull the lever up. Pull the release tab to release the suction. If the suction cup does not adhere, clean the mounting area of the windshield with a cloth dampened with isopropyl alcohol. Let the area dry, then reapply the suction cup. 4. The ball foot should now be securely fixed on the windshield. Slip the locking nut loosely over the ball foot, with the flat side facing upward. Suction cup Lever Locking nut 5. Making sure the short side of the socket clip is at the top, push the socket clip onto the ball foot until it clicks. 6. Adjust the position of the socket clip so that Delphi Mobile Navigation will be clearly visible to the driver. 7. Thread the locking nut onto the socket clip; turn clockwise until tight. 11