DELPHI NA10000-11B1 User Manual - Page 14
Screw mount to dash
UPC - 689604150672
View all DELPHI NA10000-11B1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Screw mount to dash Warning: To avoid personal injury, follow the safety guidelines and installation instructions provided so that Delphi Mobile Navigation does not obstruct the view of the driver, interfere with the operation of any airbags and safety features in the vehicle, or become airborne in the case of an accident. Do not attempt to install the Delphi Mobile Navigation unit while driving. 1. Choose a position on the dash where Delphi Mobile Navigation will be clearly visible to the driver without obstructing the driver's view. 2. Center the suction cup on the suction pad. Press the lever down until it snaps shut. 3. Fit the retainer ring inside the screw plate by sliding the four locating tabs into the corresponding slots on the underside of the screw plate. Note: Do not use the screw plate without the retainer ring and suction pad. Lever Locking nut Suction cup Suction pad Retainer ring Screw plate 4. Bring the ball foot up through the center of the screw plate. Position the ball foot by sliding the release tab through the slot on the screw plate. 5. Place the assembly into position on the dash. Use the three screws provided to fix the assembly firmly to the dash. Press the screw caps over the screw heads. Screw cap Screw Warning: Screw mount is not suitable for all dash surfaces. Dashes with soft padding may not hold the unit firmly in place. Mounting unit using screws may cause permanent damage to dash surface. 6. The ball foot should now be securely fixed. Slip the locking nut loosely over the ball foot with the flat side facing upward. Locking nut Ball foot 7. Making sure the short side of the socket clip is at the top, push the socket clip onto the ball foot until it clicks. Ball foot 14 Release tab Slot for release tab 8. Adjust the position of the socket clip so that Delphi Mobile Navigation will be clearly visible to the driver. 9. Thread the locking nut onto the socket clip; turn clockwise until tight.