DELPHI NA10000-11B1 User Manual - Page 15
Plug the other end of the power cable into the socket
UPC - 689604150672
View all DELPHI NA10000-11B1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
10. Snap Delphi Mobile Navigation onto the socket clip. First, position the two locating tabs (found on the bottom of the unit) into the corresponding slots on the socket clip. Then, snap the top side of Delphi Mobile Navigation onto the clip. To unclip Delphi Mobile Navigation from the mounting bracket, press down on the back of the upper plastic clip. Release the top of the unit. Then lift the unit out of the bottom two slots. 11. Flip the GPS antenna outward so that the antenna points horizontally. Antenna points up and out 12. Plug the 12/24V power adaptor into the cigarette lighter socket. 13. Plug the other end of the power cable into the socket on the left side of Delphi Mobile Navigation. 14. Verify that Delphi Mobile Navigation is positioned such that the GPS antenna has a clear view of the sky. Note: In most vehicles, you will need to have the engine idling in order to program your destination. You also can turn on the unit with just the accessory power (i.e., your ignition key turned to the ACC "on" position). When you turn on the engine, power may be interrupted to the unit but the programmed destination will be saved. In vehicles where accessory power is on permanently, the unit can be turned on and programmed as soon as the power adaptor is connected. Turning the engine on will not reset the unit. 15