DELPHI SA10001 Operation Guide - Page 5

3. Insert the SKYFiTM Receiver (sold separately) by first pressing in on the back of the black inset cradle in the Audio System and then letting the cradle tilt forward, carefully slide the SKYFiTM Receiver down into the tray so that the alignment tabs on the sides of the tray lineup with the slots on SKYFiTM and the connector is completely seated. Push on the top center above the display of the SKYFiTM Receiver so that it tilts back into the Audio System until a click is heard. The SKYFiTM Receiver can be removed by reversing this process. 4. Power up the SKYFiTM /Audio System combination by powering up the SKYFiTM R eceiver using the power button on the receiver or on the remote control. 5. If the display reads "ANTENNA" after powering up, check that the antenna connection is secure and completely pushed in. Next, change channels (from 0 to 1 or from 1 to 0 if the receiver is not authorized yet.) If the "ANTENNA" message remains, power down the radio, unplug the antenna, and look for any obvious damage in the connector, jack, or antenna cable. If no damage is detected, reconnect the antenna, turn the unit back on, and change channels again. If the message still appears, contact your retailer. 6. If the display reads "NO SIGNAL" after powering up, follow the instructions in the Antenna Set-up Section. Using the SKYFiTM Audio System with batteries The SKYFiTM Audio System can be used with batteries (not supplied) to allow you to listen to XM outdoors or in other locations without access to an A.C. power source. Alkaline or rechargeable NiCD batteries are recommended. Battery life will vary depending on how the system is operated and the type of batteries being used. It is recommended that the AC Adapter be the primary power source for the SKYFiTM Audio 5 System in order to preserve battery life. 1. Disconnect the power adapter from the back of the Audio System. 2. Remove the battery and antenna cable storage compartment cover, as described in #2 in the previous section.