DELPHI SA50002 Installation Guide - Page 10

9 SKYFi Car Cradle Installation user as well as access to the cassette play- 3. Clean the vehicle mounting surface with Using the enclosed car cradle mount Your SKYFi Vehicle Kit comes with a car cradle mount, which can be installed as follows: 1. First, attach all of the components as shown in figure 7 (page 8). Put your SKYFi Receiver into its car cradle and verify that the system is working. Disassemble the system, and proceed with step 2. When removing the antenna connector, be sure to push down on the tab marked "PUSH," and pull on the plastic connector directly (do NOT pull on cable). 2. Identify a hard, flat-as-possible surface within your car to allow the optimum er, power source, and antenna-cable route. In order to maximize visibility, this position should be chosen to minimize glare or direct sunlight on the display. Do not install the mount where it or SKYFi could block your vision, vehicle airbags, or controls. Do not install the mount on a leather surface. The adhesive used on the mount is not easily repositioned when installed, so please use care when choosing the location and placing the mount. Warning: The SKYFi Receiver should be placed in your vehicle where it will not interfere with the function of safety features, e.g., deployment of airbags. Failure to the enclosed Surface Preparation Cleaning Kit. Wipe with the towelette in only one direction. Do not wipe the surface in a circular motion or back and forth. Dry area with a clean, dry cloth. Wipe dry in the same direction again and then repeat this cleaning process. Allow to air dry thoroughly. 4. Clean the same surface with the enclosed Alcohol Prep Pad. Wipe in the same direction and manner as with the towelette. Dry the area with a clean, dry cloth, wiping in one direction. Allow to air dry thoroughly. Ensure that the surface is at least 60°F. SKYFi viewing position for the primary correctly place the SKYFi Receiver may result in injury to you or others.