DELPHI SA50002 Installation Guide - Page 12

11 Removing car cradle mount from your dashboard 2. If the pad fails to loosen, first warm it with a hair dryer for 2 minutes to 3 min- 4. As necessary, apply a silicon coating, such as Armor All® protectant, to the You can remove the car cradle mount from utes to soften the adhesive. Be careful dashboard surface in order to restore your dashboard by taking the following steps: not to apply too much heat, which could its shine. 1. Lift one edge of the adhesive pad gently damage the mounting surface. with fingers or the rounded edge of a spoon. Once enough of the edge is loosened to grip with your fingers, pull the pad gently from the mounting surface at Caution: Never use a commercial heat gun or paint-stripping gun. This could result in damage to the unit or to your vehicle. a 90-degree angle. Avoid using sharp 3. If any adhesive remains on the dash- tools that could damage the car interior. board surface, the adhesive can easily be removed by rubbing your thumb or finger across it.