DELPHI SA50002 Installation Guide - Page 15

XM Vehicle Antenna Installation • Firmly push the end connector of the • If you are receiving an "ANTENNA" error 14 Pre-installation signal check antenna cable into the corresponding message, do the following: color-coded connector on the cradle until 1. Turn SKYFi off, wait 10 seconds, then the connector clicks. turn back on. Caution: Installation of the XM Vehicle Antenna may require special tools as well as knowledge of vehicle mechanical procedures. If you are not comfortable with or are unsure of these procedures, please seek the services of a professional car audio installer. • Temporarily mount the antenna on top of your vehicle (make sure the vehicle surface is clean to prevent scratching it). • Re-dock SKYFi in its cradle. With power connected, check to see if you are receiving 2. Recheck antenna connection. 3. Inspect the cable to ensure it is not crimped, cut, or otherwise damaged. 4. If these actions do not have any effect, please contact your retailer. • Before starting, make sure SKYFi is not a signal and that no error messages are docked in its cradle. displayed. • On the antenna cable, locate the end • If you do not receive a signal or the connector. Note: Before making a display reads "NO SIGNAL," it may be connection, make sure the lead on the because you are inside a building or in an SKYFi Car Cradle and connector at the area where the signal is blocked. Move end of the antenna cable is free and the vehicle to another location. clear of debris.