Dacor DYWS4 Use & Care Manuals - Page 13
Accessing the Main Service Menu
View all Dacor DYWS4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Operating Your Wine Dispensing System 5. Push the purge button (P) next to the display above the bottle that has just been inserted. The food grade argon will replace the air in the bottle, assuring preservation. DACOR 2008 Red Wine 1oz 3oz P C 6oz NOTE: Dacor recommends replacing the pickup tube with each bottle change, but the pick-up tube may be washed out in a mild solution of warm water and dishwashing soap, rinsed out and reused. 6. Attach the dispensing head to a new bottle of wine according to the instructions starting on page 9. Insert the new wine bottle into the system according to the instructions on the facing page. Accessing the Main Service Menu The wine is now ready for serving. NOTE: If a Check Bottle message and/or a red light show on the control panel, they will clear after the first pour with the new bottle. Dispensing Wine To dispense, hold a glass under the spout and push one of the serving size buttons above the bottle. 1. Open the front door. 2. Lift the spout cover as shown on the facing page. 3. Slide the power switch, located on the left side of the bottle bay, all the way up, to the ON position. Wait for the unit to come on. 4. Slide the power switch down one notch to the SERVICE MODE position to access the main service menu. DACOR 2008 Red Wine 1oz 3oz P C 6oz When a bottle is empty, the message Check Bottle and/or a red light will show on the control panel. Changing Wine Bottles 1. Open the bottle bay door by turning the key in the lock. 2. With the door open, lift up on the spout cover until it locks in the up position as shown on the facing page. 3. Gripping the top of the bottle and the spout, gently pull the bottle and the head straight out of the unit. 4. Remove the pick-up tube from the head by pulling it straight down. 5. Clean the head according to the instructions in the Care and Cleaning section. 11 ON SERVICE MODE OFF Spout cover release lever (on bottom of spout cover) NOTE: When you are done using the service menu, you will need to slide the power switch up to the ON position in order to use the dispensing function of the system. After setting the switch to ON, lower the spout cover by pushing up and holding the lever on the bottom as you lower it down. Once the spout cover is closed, close the bottle bay door. Push in slightly just above the lock until it snaps shut.