Danby DDW611WLED Product Manual - Page 19

Care and maintenance - parts

Page 19 highlights

Care and maintenance FILTERING SYSTEM (cont) WARNING • Never run the dishwasher without the filters in place. • The dishwasher must never be used without the filters. • Improper replacement of the filter may reduce the performance level of the appliance and damage dishes and utensils. Open Step 1. Counter-rotate the fine filter. Step 2. Lift it up. CARING FOR THE DISHWASHER Step 3. Lift the main filter up. NOTE: If you follow the steps from step1 to step 3, the filter system will be removed; if you follow the steps from Step 3 to Step 1, the filter system will be installed. - Inspect the filters for blockage every time the dishwasher has been used. - By unscrewing the coarse filter you can remove the filter system. Remove any food remnants and clean the filters under running water. - The entire filter assembly should be cleaned once a week. CLEANING THE FILTER To clean the coarse filter and the fine filter, use a cleaning brush. Reassemble the filter parts and reinsert the entire assembly in the dishwasher, positioning in its proper location and pressing downward. WARNING When cleaning the filters, handle with care. Otherwise, the filters could be damaged and the performance of dishwasher could be reduced. The control panel can be cleaned by using a lightly dampened cloth and dried thoroughly. For the exterior use a good quality appliance polish wax. Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher. CLEANING THE DOOR To clean the edge around the door, you should use only a soft damp cloth. To avoid penetration of water into the door lock and electrical components, do not use a spray cleaner of any kind. WARNING • Never use a spray cleaner to clean the door panel as it may damage the door lock and electrical components. • Abrasive agent or some paper towel should not be used because of the risk of scratching or leaving spots on the stainless steel surface. 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43

Care and maintenance
FILTERING
SYSTEM (cont)
WARNING
• Never run the dishwasher without the filters in place.
• The dishwasher must never be used without the filters.
• Improper replacement of the filter may reduce the performance
level of the appliance and damage dishes and utensils.
Open
Step 1.
Counter-rotate the fine filter.
Step 2.
Lift it up.
Step 3.
Lift the main filter up.
NOTE:
If you follow the steps from step1 to step 3, the filter system will be
removed; if you follow the steps from Step 3 to Step 1, the filter system
will be installed.
- Inspect the filters for blockage every time the dishwasher has been
used.
- By unscrewing the coarse filter you can remove the filter system.
Remove any food remnants and clean the filters under running water.
- The entire filter assembly should be cleaned once a week.
CLEANING THE FILTER
To clean the coarse filter and the fine filter, use a cleaning brush.
Reassemble the filter parts and reinsert the entire assembly in the dish-
washer, positioning in its proper location and pressing downward.
WARNING
When cleaning the filters, handle with care. Otherwise, the filters
could be damaged and the performance of dishwasher could be
reduced.
CARING FOR THE
DISHWASHER
The control panel can be cleaned by using a lightly dampened cloth and
dried thoroughly. For the exterior use a good quality appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of
the dishwasher.
CLEANING THE DOOR
To clean the edge around the door,
you should use only a soft damp cloth.
To avoid penetration of water into the
door lock and electrical components,
do not use a spray cleaner of any
kind.
WARNING
• Never use a spray cleaner to clean the door panel as it may
damage the door lock and electrical components.
• Abrasive agent or some paper towel should not be used because
of the risk of scratching or leaving spots on the stainless steel
surface.
18