Danby DWC93BLSST Product Manual - Page 7

Operating Instructions The Controls of your Wine Cooler °& °) 1. Indicator light illuminates to signify the cooling mode is currently in operation. 2. ' ' Button To control this appliance turn ON/OFF ( press and hold this buttons for approximately 3 seconds). 3. ' ' Button To control the inner light turn ON/OFF. (If you press this button, the inner light is not controled by extrusion-board of lamp swith, and keep lighting.) 4. °C / °F Adjacent indicator light denotes which scale of temperature is displayed. 5. ' ' Button Used to raise (warmer) the temperature in 1° degree increments. ' ' Button Used to decrease (cooler) the temperature in 1° degree increments. Setting the Temperature NOTE When you plug in your wine cooler for the first time, the temperatures will automatically be set to 54°F (12°C) and will be displayed in the Fahrenheit scale (°F). • To switch the display between the Fahrenheit (°F) and Celsius (°C) scale, depress the and control buttons simultaneously for approximately five(5) seconds. • The temperature range can be set as low as 39°F (4°C) or as high as 64°F (18°C) to suit your specific storage requirements. Each depres- sion of the or but- ton will allow you to adjust the temperature in 1° degree increments within the afore- mentioned range. Function instruction NOTE If too many bottles are put in at once or the door has not been closed tightly, the unit will display the "HI" signal in the display panel. This is normal. Please wait 5 minutes after you close the door and "HI" will disappear. It is normal that the cabinet shows "HI" or "LO" from time to time, If it occurs frequently or lasts for a long time, you can restart the unit by unplugging it. If the problem occurs once again after restart, please contact customer service. • Temperature Memory Function In the event of a power interruption the Wine Cooler can remember the previous temperature settings, and when the power is restored the cabinet temperature will go back to the same setting temperature as before. • Door Ajar Alarm Function If the door is not closed completely the alarm will sound after 5 minutes. Please close the door completely to avoid the loss of cold energy. • Temperature Alarm Function If inner temperature is higher than 74°F(23°C), "HI" is shown in the display panel, and the alarm will sound after one hour. It informs you that the inner temperature is too high, please check the reason. If inner temperature is lower than 34°F(1°C), "LO" is shown in the display panel and the alarm will turn on. 6