Danby DWC93BLSST Product Manual - Page 9

Installation Instructions - Intergrated Application Tools You Will Need Safety Glasses Gloves Level FOR YOUR SAFETY  While performing installations described in this section, gloves, safety glasses or goggles should be worn. Drill & Hole Saw Set Flashlight Measuring Tape Carpenters Square Preparing the Enclosure Electrical Requirements: The appliance must be connected to an individual properly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker or time delay fuse. IMPORTMANT ! Door Swing Do not include the door within the enclosure; leave it outside of the enclosure to prevent the door swing from being obstructed. • It is recommended that you do not install the Wine Cooler into a corner (i.e. directly beside a wall). This is to allow the door(s) to have a greater then 90° opening swing. A limited door swing will prevent the shelves from sliding out as intended, and may lead to damaging the door gasket(s). • The rough cabinet opening must be on a level floor area and at least 26" deep (66.04cm) by 15"(38.1cm) wide. The opening should also have a height of at least 34 1/16"(86.52cm). Fig D • The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig D). Important˖ If the electrical outlet is surface mounted (not flush) within the enclosure, the depth requirement for the installation may be affected. • If the electrical outlet is located inside the adjacent cabinetry, cut a 1-1/2"(3.81cm) diameter hole to admit the power cord. If the cabinet wall is metal, the hole edge must be covered with a bushing or grommet. Fig D 1 26" min. depth 2 341/16" from underside of countertop to floor. 3 15" min. width 4 2" of depth given for Elec. Access* 5 1 1/2" dia. hole (if outlet is inadjacent cabinetry). 6 Cabinets square and plumb *The listed depth requirement for the installation is assuming that the electrical outlet is located in the adjacent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure. 8