Dell Alienware m16 R1 AMD Service Manual - Page 56
Fan and heat-sink assembly, Removing the fan and heat-sink assembly
![]() |
View all Dell Alienware m16 R1 AMD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
9. Connect the camera cable to the system board. 10. Adhere the tape securing the camera cable to the system board. 11. Connect the rear I/O board cable to the system board. 12. Connect the touchpad cable to the system board and close the latch to secure the cable. 13. Connect the speaker cable to the system board. Next steps 1. Install the battery. 2. Install the rear-I/O cover. 3. Install the small fan. 4. Install the wireless card. 5. Install the 2230 solid-state drive in slot three. 6. Install the 2280 solid-state drive or 2230 solid-state drive in slot one and two, whichever applicable. 7. Install the memory. 8. Install the base cover. 9. Follow the procedure in After working inside your computer. Fan and heat-sink assembly Removing the fan and heat-sink assembly Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the base cover. 3. Remove the 2230 solid-state drive in slot three. 4. Remove the 2280 solid state drive or 2230 solid-state drive in slot one and two, whichever applicable. 5. Remove the wireless card. 6. Remove the small fan. 7. Remove the rear-I/O cover. 8. Remove the battery. 56
![](/manual_guide/products/dell-alienware-m16-r1-amd-service-manual-ff96588/56.png)