Dell DS-32M2 Installation Guide - Page 10

use an M5 x 12 mm, screw to install the latch bracket in the center hole, over

Get Dell DS-32M2 PDF manuals and user guides View all Dell DS-32M2 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Installing the DS-16M and DS-32M Rails 7. If you are installing the switch in a 39U cabinet, position the #10 washer and ball stud in the center hole, between the two M5 x 12 mm screws. Hand-tighten the ball stud. NOTE: The ball studs support the bezel. If you are installing the switch in a 40U cabinet, use an M5 x 12 mm screw to install the latch bracket in the center hole, over the keyplate spacer. See the figure below. Keyplate Latch Spacer Bracket Screw EMC2422 8. Align the holes in the rear, u-shaped flange of the rail with the holes in the rear inside channel. Rear (u-shaped) flange 10 EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
10
EMC Departmental Switches DS-16M2 and DS-32M2
Installation Guide
Installing the DS-16M and DS-32M Rails
7.
If you are installing the switch in a 39U cabinet,
position the #10
washer and ball stud in the center hole, between the two
M5 x 12 mm screws. Hand-tighten the ball stud.
NOTE:
The ball studs support the bezel.
If you are installing the switch in a 40U cabinet
, use an M5 x 12 mm
screw to install the latch bracket in the center hole, over the
keyplate spacer. See the figure below.
8.
Align the holes in the rear, u-shaped flange of the rail with the
holes in the rear inside channel.
EMC2422
Latch
Bracket
Screw
Keyplate
Spacer
Rear (u-shaped)
flange