Dell Force10 C300 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 577
interface range macro define, Multiple Range Bulk Configuration with SONET, VLAN, and port channel
View all Dell Force10 C300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 577 highlights
The following figure shows how to use commas to add SONET, VLAN, and port-channel interfaces to the range. Example Figure 23-14. Multiple Range Bulk Configuration with SONET, VLAN, and port channel FTOS(config-if)# interface range gigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2, Vlan 2 - 100 , Port 1 - 25 FTOS(config-if-range)# no shutdown FTOS(config-if-range)# Related Commands interface port-channel interface vlan show config (from INTERFACE RANGE mode) show range interface range macro (define) Configure a port channel group. Configure a VLAN interface. Show the bulk configuration interfaces. Show the bulk configuration ranges. Define a macro for an interface-range. interface range macro (define) c e s Defines a macro for an interface range and then saves the macro in the running configuration. Syntax define interface range macro name interface , interface , ... Parameters name interface , interface ,... Enter up to 16 characters for the macro name. Enter the interface keyword (see below) and one of the interfaces slot/ port, port-channel or VLAN numbers. Select the range of interfaces for bulk configuration. You can enter up to six comma separated ranges-spaces are not required between the commas. Comma-separated ranges can include VLANs, port-channels and physical interfaces. Slot/Port information must contain a space before and after the dash. For example, interface range gigabitethernet 0/1 - 5 is valid; interface range gigabitethernet 0/1-5 is not valid. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults This command has no default behavior or value Command Modes CONFIGURATION Interfaces | 577